TM 1-1520-238-23
11-1271
11.296.
RIGGING TAIL ROTOR DIRECTIONAL FLIGHT CONTROLS – continued
11.296.3. Rigging
a. Enter pilot station (para 1.56). Observe all
safety precautions.
b. Move pilot right directional pedal (1) forward
until it contacts stops.
(1) Hold pedal (1) in this position.
c. Check that rigging tool (2) contacts mast base
(3) and alines with de-ice housing (4).
(1) Install rigging tool (2) between tail rotor gear-
box mast base (3) and swashplate de-ice
housing (4). Use flight control rigging kit.
(2) Hold rigging tool (2) firmly against mast base
(3).
(3) Check that inboard edge of de-ice housing (4)
falls within right pedal position limitations (5)
specified on rigging tool (2).
(4) If inboard edge of de-ice housing (4) does not
aline within limits (5), adjust directional servo-
cylinder rod end (para 11.297).
(5) If inboard edge of de-ice housing (4) alines
within limits (5), go to next step.
d. Remove rigging tool (2) from between tail ro-
tor gearbox mast base (3) and swashplate de-
ice housing (4).
e. Move pilot left directional pedal (6) forward
until it contacts stop.
(1) Hold pedal (6) in this position.
GO TO NEXT PAGE
PILOT STATION
1
M04-3029-5
M04-3029-3
2
2
3
4
5
M04-3029-7
PILOT STATION
6
M04-3029-8
