TM 1-1520-238-23
11-1268
11.295.
RIGGING PILOT AND CPG DIRECTIONAL PEDAL STOP BOLTS – continued
p. Observe piston (19) travel.
q. Fully extend piston (19) by slowly pushing pi-
lot left pedal (2) forward.
(1) Slowly push pedal (2) forward until piston (19)
is fully extended.
(2) Hold pedal (2) in this position.
r. Measure and record distance between valve
arm (9) and stop bolt (10) on servocylinder (7).
(1) This is measurement C. Use caliper.
(2) If difference between measurements A and C
is more than 0.270 INCH, move pedal (3)
forward until difference between measure-
ment A and measurement B is between 0.210
and 0.270 INCH.
(3) If difference between measurements A and C
is less than 0.210 INCH, move pedal (2) for-
ward until difference between measurement
A and measurement C is between 0.210 and
0.270 INCH.
(4) If difference between measurements A and C
is between 0.210 and 0.270 INCH go to next
step.
(5) Hold pedals (2) and (3) in this position.
GO TO NEXT PAGE
M04-3028-11
19
PILOT STATION
M04-3028-16
2
3
M04-3028-13
C
10
9
7
