TM 1-1520-238-23
2-693
2.195.
WIRE STRIKE PROTECTION AIRCRAFT CABLE CUTTER BLADES REPLACEMENT – continued
2.195.6. Installation
a. Install new blades (1) and (2).
(1) Aline blades (1) and (2) with mounting holes
of two plates (6).
(2) Add shims (7) (as required) between blades
(1) and (2).
(a) Check two plates (6) to provide a gap of
0.16 INCH maximum.
(b) Ensure cutting edge of blades (1) and (2)
are alined.
(3) Remove blades (1) and (2) from between two
plates (6).
NOTE
Blades must be installed while sealant is
wet.
(4) Apply a thin coat of sealant to blades (1) and
(2). Use sealing compound (item 177, App F)
and brush (item 34, App F).
(5) Install 8 screws (3), 16 washers (5), and 8
nuts (4) on 2 plates (6) and cutters (1)
and (2).
(6) Measure gap at rear of blades (1) and (2) with
blades (1) and (2) forced apart. Gap should
be no more than 0.020 INCH.
(7) Tighten eight nuts (4). Use socket head key
set.
(8) Apply a coat of sealant to exposed portions of
blades (1) and (2). Allow to air dry. Use
sealing compound (item 177, App F) and
brush (item 34, App F).
b. Inspect (QA).
END OF TASK
6
M04-3541-2
7
1
7
2
4
5
6
3
5
7
7
