TM 1-1520-238-23
3-122
Change 6
3.35.
TAIL LANDING GEAR ACTUATING CYLINDER LOCK RELEASE HANDLE
REPLACEMENT continued
b. Remove bolt (14) from handle (1).
(1) Remove lockwire from bolt (14).
(2) Hold bolt (14). Loosen nut (15).
(3) Remove bolt (14), nut (15), and washer (16).
3.35.4. Cleaning
a. Wipe removed and attaching parts with a
clean rag.
3.35.5. Inspection
a. Check removed and attaching parts for corro-
sion (para 1.49).
b. Check cylinder for cracks or leaks. None al-
lowed.
3.35.6. Installation
a. Install bolt (15) in handle (1).
(1) Install nut (15) and washer (16) on bolt (14).
(2) Install bolt (14) in handle (1). Do not tighten
nut (15).
b. Install handle (1) on cylinder (2).
(1) Install pin (10) through two washers (9) and
pivot point (11).
(2) Install two rings (8) on pin (10). Use retaining
ring pliers.
(3) Install pin (6) through two washers (5) and
attachment point (7).
(4) Install two rings (4) on pin (6). Use retaining
ring pliers.
(5) Install pin (13) through handle (1).
(6) Install two rings (12) on pin (13). Use
retaining ring pliers.
(7) Install two springs (3) on pin (13).
GO TO NEXT PAGE
M04-2294-3A
7
11
1
3
8
9
8
9
1
2
10
4
5
12
7
6
5
4
12
13
1
15
14
16