TM 1-1520-238-23
Change 3 8-105
8.39.
PITOT STATIC SYSTEM TUBING SPLICE REPLACEMENT – continued
(9) Allow 24 HOUR cure time.
c. Install splice (1) over tubing (2) and tubing (6).
(1) Cut one 1.0 INCH splice from sleeving instal-
lation. Use insulation sleeving (item 104,
App F).
(2) Slide splice (1) over tubing (2).
(3) Abrade end of tubing (6) 1.0 INCH. Use cloth
(item 48, App F).
(4) Install tubing (6) into tubing (2) 0.50 INCH.
(5) Apply adhesive to splice area. Fill in all val-
leys of tubing (2). Use adhesive (item 9,
App F).
(6) Slide splice (1) over tubing (6) and tubing (2)
0.50 INCH over each tube.
(7) Shrink splice (1) down over tubing (2) and
tubing (6). Move heater tubing slowly to en-
sure proper shrinkage of sleeving. Use
protective gloves and heater.
(8) Remove all excess adhesive. Use methyl
ethyl ketone (item 124, App F) and cloth
(item 52, App F).
(9) Allow 24 HOUR cure time.
GO TO NEXT PAGE
M04-3732-4
1
6
2
0.50
1.00
