TM 1-1520-238-23
11-662
11.150. PILOT STATION DIRECTIONAL BELLCRANK BRACKET ASSEMBLY
REMOVAL/INSTALLATION – continued
11.150.3. Removal
NOTE
A laminated spacer is installed between
the bracket and the airframe. Use care
when removing the bracket to prevent the
spacer from delaminating.
a. Remove pilot directional bellcrank bracket as-
sembly (1) from airframe (2).
(1) Remove five nuts (3) and washers (4).
(2) Remove three bolts (5) and shim (6).
(3) Remove two bolts (7).
(4) Remove bracket (1).
NOTE
If the bracket is to be replaced, perform
step b.
b. Remove two stop bolts (8), nuts (9), and wash-
ers (10) from bracket (1).
(1) Measure and record length from top of bolt
(8) to bracket (1) body (two places).
(2) Remove lockwire from two bolts (8).
(3) Remove two bolts (8), nuts (9), and washers
(10) from bracket (1).
GO TO NEXT PAGE
M04-4411-2
7
5
6
2
3
4
3
1
4
M04-4411-3
8
10
9
1
