TM 1-1520-238-23
Change 8
16-23
16.4.
PYLON RACK REMOVAL/INSTALLATION - continued
CAUTION
Do not apply corrosion preventive com-
pound on individual components after or
during assembly. Application will result in
wet (lubricated) torque which can result in
a much higher torque value than speci-
fied.
NOTE
Do not use corrosion preventive film
on weapons pylons (Teflon coated)
pivot
pins,
part
number
7-318000061-3.
New pylon rack initially requires two
applications of corrosion preventive
compound, which must be applied in
intervals at least one hour apart.
When applying corrosion preventive
compound, use the precision (straw-
like) applicator attached to the spray
head of aerosol can.
After two minutes, wipe excess corro-
sion preventive compound from ap-
plied area.
o. Apply corrosion preventive compound to py-
lon rack pivot points. Use corrosion preventive
compound (item 63, App F). Make application in
single short duration squirts, to the following
areas.
(1) Forward hook shaft (39) inboard and out-
boards sides of rack (28).
(2) Aft hook shaft (40) inboard and outboard
sides of rack (28).
(3) MANUAL RELEASE pivot point (41) inboard
and outboard sides of rack (28).
GO TO NEXT PAGE
28
M04-1229-12A
39
41
40
