TM 1-1520-238-23
Change 1
4-659
4.183.
NO. 2 ENGINE POWER AVAILABLE SPINDLE (PAS) RIGGING PROCEDURE – continued
x. Set pilot power levers (3) and (7) to OFF posi-
tion.
y. At HMU spindle gearbox (32), obtain 0.010 to
0.050–INCH gap between spindle stop (33)
and spindle cam (34). Use gap setting gage.
NOTE
If 0.010 to 0.050 INCH clearance cannot
be obtained, go to step b and repeat pro-
cedures.
z. Adjust power lever (3) OFF stop screw (2).
(1) With power lever (3) OFF position, adjust
screw (2) until it touches power lever (3).
aa. Set power lever (3) to LOCKOUT position.
NOTE
If Hamilton Standard HMU is installed,
perform step ab. If Woodward HMUs
installed, perform step ac.
GO TO NEXT PAGE
M04-1208-27A
3
7
34
33
M04-1208-46
32
.010
TO .050
M04-1208-47A
3
2
M04-1208-30A
3
