TM 1-1520-238-23
Change 8
16-79
16.17.
PYLON STOW BRACKET REMOVAL/INSTALLATION - continued
(9) Install bottom receptacle (15).
(a) Install forward outboard screw (17).
(b) Install cover chain (20) on forward out-
board screw (17).
(c) Install three screws (17), eight washers,
(18), and four nuts (19).
(10) Install cover (16) on connector (15).
c. Repair bracket (1) by replacing cover (16) and
chain (20).
(1) Remove cover (16) from receptacle (15).
(2) Remove nut (19) and washer (18) from re-
ceptacle mounting screw (17).
(3) Remove and discard cover (16) and chain
(20).
(4) Wipe receptacle (15) with a clean rag.
(5) Install new cover (16) with chain (20) on re-
ceptacle (15).
(6) Install chain (20), washer (18), and nut (19)
on mounting screw (17).
(7) Install cover (16) on receptacle (15).
d. Repair bracket (1) by replacing quick-release
pin (22) or lanyard (23).
(1) Remove screw (24), nut (25), and washer
(26).
(2) Remove and discard lanyard (23) or pin (22)
from ring (27).
(3) Install new lanyard (23) or new pin (22) on
ring (27).
(4) Insert screw (24) through two lanyard tabs
(28). Install screw (24) on bracket (1).
(5) Hold screw (24). Install washer (26) and nut
(25).
GO TO NEXT PAGE
18
17
M04-2850-5
20
16
15
1
19
18
26
23
27
22
1
28
24
25
M04-2850-6
